fpga_load − Xorcom Astribank (xpp) firmware tool |
fpga_load [-g] [-r] [-v] -D {/proc/bus/usb|/dev/bus/usb}/BUS/DEV fpga_load [-g] [-v] -D {/proc/bus/usb|/dev/bus/usb}/BUS/DEV -I firmware.hex [-b dump.bin] [-i] fpga_load -h |
fpga_load loads the FPGA firmware to the Xorcom Astribank device. The syntax resembles that of fxload(8). |
-b dump.bin |
Before writing firmware, bump the processed binary file to dump.bin. |
-D DEVICE |
Required. The device to read from/write to. On modern UDEV-based system this is usually /dev/bus/usb/bus_num/device_num, where bus_num and device_num are the first two numbers in the output of lsusb(8). On older systems that use usbfs, it is usually /proc/bus/usb/bus_num/device_num. |
-r |
Reset the Astribank and renumerate its USB connection to power on product ID. |
-g |
Dump all eeprom data to standard output. |
-I fireware_file |
The firmware file to write to the device. |
-i |
Show information about the firmware file (valid only with -I option). Example: |
./FPGA_1151.hex: Version=3297 Checksum=58270 |
In particular, the calculated checksum should match the output of sum(1) on the binary firmware file generated by the -b option. |
-v |
Increase verbosity. May be used multiple times. |
-h |
Displays usage message. |
fxload(8), lsusb(8) |
This manual page was written by Tzafrir Cohen <tzafrir.cohen@xorcom.com> . Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation. On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL. |