|
astribank_tool − Xorcom Astribank (xpp) firmware loader |
|
astribank_tool -D device-path <-F|-p> [options] hexfile astribank_tool [-h] |
|
astribank_hexload is a second-stage firmware loader for Xorcom Astribanks. Note that some older models use fpga_load(8) instead. It is used to load a file in the Intel HEX format into a Xorcom Astribank. It can be used to load either an FPGA firmware or a PIC firmware. It is normally run by the script xpp_fxloader. |
|
-D device-path |
|
Required. The device to read from/write to. On modern UDEV-based system this is usually /dev/bus/usb/bus_num/device_num, where bus_num and device_num are the first two numbers in the output of lsusb(8). On older systems that use usbfs, it is usually /proc/bus/usb/bus_num/device_num. |
|
-F |
|
The firmware to load is a FPGA firmware. |
|
-p |
|
The firmware to load is a PIC firmware. |
|
-v |
|
Increase verbosity. May be used multiple times. |
|
-d mask |
|
Set debug mask to mask. Default is 0, 0xFF is "everything". |
|
-h |
|
Displays usage message. |
|
fxload(8), lsusb(8), astribank_tool(8), fpga_load(8) |
|
This manual page was written by Tzafrir Cohen <tzafrir.cohen@xorcom.com> . Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation. On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL. |