dahdi_hardware − Shows Dahdi hardware devices.
dahdi_hardware [−v][−x]
|
−v |
Verbose output − show spans used by each device etc. Currently only implemented for the Xorcom Astribank. | ||
|
−x |
Show disconnected Astribank unit, if any. |
Show all Dahdi hardware devices. Devices are recognized according to lists of PCI and USB IDs in Dahdi::Hardware::PCI.pm and Dahdi::Hardware::USB.pm . For PCI it is possible to detect by sub-vendor and sub-product ID as well.
The first output column is the connector: a bus specific field that shows where this device is.
The second field shows which driver should handle the device. a "−" sign marks that the device is not yet handled by this driver. A "+" sign means that the device is handled by the driver.
For the Xorcom Astribank (and in the future: for other Dahdi devices) some further information is provided from the driver. Those extra lines always begin with spaces.
Example output:
Without drivers loaded:
usb:001/002 xpp_usb− e4e4:1152 Astribank−multi FPGA−firmware usb:001/003 xpp_usb− e4e4:1152 Astribank−multi FPGA−firmware pci:0000:01:0b.0 wctdm− e159:0001 Wildcard TDM400P REV H
With drivers
loaded, without −v:
usb:001/002 xpp_usb+ e4e4:1152 Astribank-multi FPGA-firmware
usb:001/003 xpp_usb+ e4e4:1152 Astribank-multi FPGA-firmware
pci:0000:01:0b.0 wctdm+ e159:0001 Wildcard TDM400P
REV E/F
With drivers
loaded, with −v:
usb:001/002 xpp_usb+ e4e4:1152 Astribank-multi FPGA-firmware
LABEL=[usb:123] CONNECTOR=usb−0000:00:1d.7−1
XBUS−00/XPD−00: FXS Span 2
XBUS−00/XPD−10: FXS Span 3
XBUS−00/XPD−20: FXS Span 4
XBUS−00/XPD−30: FXS Span 5
usb:001/003 xpp_usb+ e4e4:1152 Astribank-multi FPGA-firmware
LABEL=[usb:4567] CONNECTOR=usb−0000:00:1d.7−4
XBUS−01/XPD−00: FXS Span 6 XPP-SYNC
XBUS−01/XPD−10: FXO Span 7
XBUS−01/XPD−20: FXO Span 8
XBUS−01/XPD−30: FXO Span 9
pci:0000:01:0b.0 wctdm+ e159:0001 Wildcard TDM400P
REV E/F